Satellite TV Installation Guide

For those who prefer to install the satellite dish on their own time here is an article to help you. Installing a dish is something done by most companies today but you can still do it on your own if you choose too. The following will help guide you through that process.

Some of the tools needed for the installation will include open end wrenches. An adjustable wrench is fine and will also do the job. You are also going to want a ratchet tool, a hex nut tool, an electronic drill, drill bits, a pencil, screwdrivers, and a compass. Also remember, before you start to do anything, plan it all out. If you do not have a plan to follow you are asking for trouble.

In fact, locating the right site which does not have an unobstructed view is probably the hardest step in the whole process. If your view is bad, your reception is going to be too. So how do we come to a proper conclusion on this topic? Let us take a look at what we have as options.

There are a series of steps you are going to want to take. You want to find where the satellite is in the sky in relation to your house. You want to find potential places where you will mount the satellite. You want to find all the cables required and then finally choose the best place to mount the satellite.

There are many places to mount the satellite dish depending on where you plan to put it. Different positions require different installations. You mount it on wood, brick, a pole, the chimney, the roof, and so on.

If you decide to mount it on brick as most folks do, do not make any holes in the mortar between the bricks. You want to drill into the actually brick so as to keep the dish stable, level, and sturdy. If you are unsure about any risk on the home please consult someone before doing so.

Another major factor in putting a dish on your house is deciding where and how to run the cable to your receiver. You do not want to have more than 112 feet of cable running from the outside to your set in the house. It causes problems and just try to avoid this at all costs. If you are installing your dish on the chimney, make sure that it has an unobstructed view from the side walls. Although this seems obvious, a lot of folks miss this step.

Take into consideration the fact of trees, power lines, branches, fences, any kind of that stuff. What if you have to climb a ladder to install the equipment on your roof? Plan ahead and know how you plan to get all the equipment up the ladder while you are climbing it. Make sure to ground the dish, to be careful when drilling into your house, and to rout the coaxial cables. Keep a steady head and you will be alright. Good luck with your installation!